11.1V | 6.000mAh LiPo Battery Heating Pack "Pro-Push-2-DP" With Illuminated Push Button Heating Control, Incl. Charger

The LiPo battery packs come with an illuminated push button heater control. The push button is slightly raised and thus unerringly accessible. Its slight click when pressed provides tactile and audible feedback. This ensures that the setting of a desired heating level is optimally fulfilled.

The battery pack is switched on after pressing the button for 2 seconds at the highest heating level. After two further heating levels of 75% and 50%, the heating level starts again at 100%. The heating control is switched off with a 2-second push. The heating levels are indicated by illuminating the pushbutton in the colors red - blue - green.

Notes & Features About the Accumulators

The excellent quality of the individually tested battery packs, the very high-quality selection of the raw materials used, and the electronic protective circuits integrated into the battery packs, which include 

• Automatic switch-off 
• Balancer technology
• Deep discharge protection
• Short circuit with reverse polarity protection
• Charge overvoltage protection
• Discharge current control
• Temperature protection
• Certifiied Safetyregulations: UN38.3 (Report No. 1815C50005212701), Material Safety Data Sheet (MSDS 1815C50005212704)

These battery-features offer the greatest possible safety for demanding applications and thus correspond to professional battery technology and brand quality, which also stands for a very long battery life. The battery covered with a water-repellent, skin-friendly textile is e.g. inserted into the breast pocket or battery pocket of an undershirt or underpants or connected to a heating mat. The charging time of a battery is about 3 hours with the electronically regulated 1A charger.

A battery capacity of 12.0Ah is available on request!

The battery pack with the heating control is carried in the jacket or trouser pocket. The battery pack can also be attached to the forearm or thigh by means of Velcro.

Furthermore, belt clip pouches made of tear-proof Cordura are offered for individual battery packs. For professional use, battery belts are used for battery expansion of up to 24Ah.

For connection to the heating shirt or heating mat, supply cables with different lengths and waterproof connections are offered as accessories.

For example, the battery is carried in a jacket pocket and is to be connected by means of parallel Y-adapters to the cable connection with 2 upward led outlets for the heated underwear or for the gloves.

Alternatively, the battery is attached to a forearm using Velcro, with one Y-outlet pointing forward to the glove and the other back to the upper arm, with a 120cm or 180cm extension cable leading to the other glove.
You can specify the desired battery variants when ordering.

The heating power when using heated gloves is approximately 35 watts with freshly charged batteries and 30 watts at nominal 11.1V. The heating power of the heatable underwear or heating mats corresponds to that of the gloves. Battery technology and heating power are optimally matched. However, if the current load exceeds 35 watts, e.g. because another heating garment is to be connected, a second battery pack is required to increase the current load capability and capacity. We can assemble further battery packs according to your needs (as double, triple or quadruple pack on top of each other or according to length or width next to each other).

The small and lightweight battery pack convinces with high storage capacity and integrated protection electronics such as balancer technology, deep discharge protection, overvoltage and automatic shutdown. The battery, which is covered with a water-repellent, skin-friendly textile, is inserted, for example, into the breast pocket or battery pocket of an undershirt, undershirt or undershorts, or connected to a heating mat. The charging time of a battery is about 3 hours with the electronically controlled 1A fast charger.