14.8V | 5,000mAh LiPo Battery Heater Pack "XPro-Dive-Touch-1k" With Magnetic Heater Control for Dive Heating Clothing

14.8V | 5,000mAh LiPo Battery Heater Pack "XPro-Dive-Touch-1k" with Magnetic Heater Control for Dive Heating Clothing

The waterproof LiPo battery pack comes with a proximity sensor control that is worn under both wet and dry diving suits and is used to switch and set the desired heating levels of connected heatable underwear e.g. DiveShirt or DivePant. The 4-stage diver heating control, supplied with waterproof connectors, is switched contact-free through the diving suit. The diver control is activated by a magnet attached to the finger with non-slip, double-sided Velcro tape, which swipes across the sensor system at a distance of up to 30mm, switching the battery on to maximum power. Another swipe across advances the heat levels in 25% increments, to HIGH, MEDIUM, LOW and then OFF. The non-contact switching sensor technology is ideal for applications where the control is worn under the wetsuit. The amount of heating power is indicated by an LED. The proven diving depth of the diving control is 150m.

Examples of Applications for a Heating Garment
The battery pack with diver control is carried in the battery pocket of the DiveShirt in the area of the abdominal cavity or on the thigh of the DivePants.
The battery pack is attached to the forearm or thigh using Velcro. For the connection to the heating shirt, supply cables with different lengths and waterproof connections are offered as accessories.

Application Examples for Heating Gloves or 2 Heating Garments
The battery is worn, for example, in the area of the abdominal cavity and allows by means of parallel Y-adapter the cable connection with 2 outputs led upwards for the heated underwear or for the gloves. Alternatively, the battery is attached to a forearm using Velcro, with one Y-outlet pointing forward to the glove and the other back to the upper arm, with a 120cm or 180cm extension cable leading to the other glove. You can specify the desired battery variants when ordering.
The heating power is approx. 65 Watt with freshly charged battery pack and 50 Watt with nominal 14,8V battery voltage when using the heated Dive-Shirt. The heating power of the "inDive" diving gloves or heating mats corresponds to that of the heatable underwear. Battery technology and heating power are optimally matched. However, if the current load exceeds 70 watts, e.g. because additional heated clothing is to be connected, a 2nd battery pack is required to increase the current load capability and capacity. We will be pleased to assemble further battery packs according to your needs (as double, triple or quadruple pack on top of each other or according to length or width next to each other).

Notes & Features About the Accumulators
The excellent quality of the individually tested battery packs, the very high-quality selection of the raw materials used, and the electronic protective circuits integrated into the battery packs, which include 

• Automatic switch-off 
• Balancer technology
• Deep discharge protection
• Short circuit with reverse polarity protection
• Charge overvoltage protection
• Discharge current control
• Temperature protection

offer the greatest possible safety for demanding applications and thus correspond to professional battery technology and brand quality, which also stands for a very long battery life. The battery, which is covered with a water-repellent, skin-friendly textile, is inserted, for example, into the breast pocket or battery pocket of an undershirt, diving shirt or underpants, or connected to a heating mat. The charging time of one battery is about 2.5 hours.

---

Sealing Bath for Waterproof Batteries

Water resistance protects battery, electronics and cable contacts against sea salt water when penetrating the dry suit.

Waterproof to IP69K: Protected from water intrusion during temporary flooding..




(Fig. 1: Battery after the sealing bath)



(Fig. 2: left battery after sealing bath, right battery before treatment).